Acon Industries - Asphalt and Chipseal Services
  • Surfacing
    • Asphalt
    • Chipseal
    • Base
  • Our Projects
    • Commercial
    • Residential
  • Why Acon
    • Project Partners
    • Customer Feedback
  • Our Gear
  • About Us
    • Meet The Team
    • Contact
  • News

Enviro asphalt - it's all in the tyres

28/3/2019

 
Picture
Over 27 million tyres end up in landfills, dumps and stockpiles every year, where they become a serious health and environmental hazard. Now, with the advances in technology and science, researchers are discovering that tyres could be used to provide the base material for our roads. Previously blends of ground tyres and asphalt could be unstable. However, researchers have now identified polymer additives that increase the storage stability of asphalt rubber. 
Because rubber is so resilient, scrap tyres stay in the environment for a long time, creating fire hazards and breeding grounds for rodents and mosquitoes. This durability could make tires advantageous for producing rubber asphalt -- a mixture of ground tire rubber and bitumen (asphalt) used to pave and repair roads. Currently, about half of U.S. states use ground tire rubber as a component of asphalt mixes, citing better performance than regular asphalt, cost-effectiveness and environmental benefits. However, the material has two major challenges that limit wider use: its high viscosity and tendency to separate into rubber and bitumen layers during storage. Christopher Williams, Eric Cochran and colleagues wanted to identify polymer additives that mitigate these problems.
​

The researchers studied the stability of rubber asphalt made by blending and extruding different amounts of the polymers cis-isoprene, trans-isoprene, polybutadiene or polyisobutylene with ground tire rubber. The team found that, when mixed with asphalt, blends of ground tire rubber with trans-isoprene or polybutadiene in a 3:1 ratio performed the best. These mixtures reduced the density of ground tire rubber so that it was similar to asphalt and did not settle during storage. The polymers also helped reduce the viscosity of the rubber asphalt so that the material was easier to work with. According to the researchers, the polymer additives are cost-effective, resulting in savings of about 7 to 10 percent compared with regular asphalt.

Comments are closed.

    RSS Feed

Picture
Acon Industries is approved & registered on the Local Authority Contractor Pre-Qualification Database Ref. No. P2OJD3V527
Picture
Full Member
Picture
Completed workplace compliance review in Employment Relations and Health & Safety
Picture
Full Member
Picture
Picture
Picture
Post: PO Box 16363, Bethlehem, 3147
Visit: Cnr SH2 & Clark Rd, Te Puna
Phone: 07 552 6757
Email: Email us here
Follow Us: On Facebook here
 © Acon Industries Ltd 2018 | Site by Formula One Results & Whitfield Consulting
  • Surfacing
    • Asphalt
    • Chipseal
    • Base
  • Our Projects
    • Commercial
    • Residential
  • Why Acon
    • Project Partners
    • Customer Feedback
  • Our Gear
  • About Us
    • Meet The Team
    • Contact
  • News